What Will cause Embroidery Machine thread to break?
What Will cause Embroidery Machine thread to break?
Your machine is not properly threaded; Re-threading your machine ensuring the thread has gone through each of the guides along with the tension properly to suit your embroidery designs downloads
There could be burrs within the needle’s eye, on the thread guides, needle plate or the hook; Replace the needle and try buffing the thread guides and needle plate. Buffing may alter the timing, so it might be wise to replace a damaged hook.
Dry Hook; Since it dries out fastermore quickly, the hook needs routine lubrication. The hook assembly must be lubricated every 4-8 hours of machine running time.
Needle to smallsmaller; You might have to convert to a bigger needle
An excessive amount of Adhesive spray; You ought to be using only Embroidery design adhesive sprays, do not over use them. An excessive amount of adhesive build-up on the needle can make them drag and break threads. If this is occurring you might want to examine the way you use your adhesive spray
Incorrect timing; If the machine isn’t timed correctly, it can cause many problems as well as thread breaks. Such as, broken needles, poor stitching or sometimes no stitching.
Old Thread; Thread can be brittle with age and long contact with light, air as well as heat. You ought to keep your thread within a cool, dark place to increase shelf life.
Bruised cone; A bruised spool of thread can occur if the thread falls on the floor, causing the lower winding of thread to undo and catch as the thread spools off. You could take off the affected section of the thread or switch the cone.
Machine speed; A few of theembroidery designs increase the stress on thread. You need to lower the machine speed when needed
Lint build up; A lint build up around the tension discs, needle plate or bobbin cases may cause breakage. These areas ought to be cleaned regularly with air or possibly a brush.
Bent needle; This could happen after the needle hits a really hard object possibly Hoop, needle plate or the hook. If this occursyou will need to change the needle and search for burrs as well as the timing.
Improper tensions; If your tension is too tight, you can get pulling, puckering and thread stress. When the thread is too loose it may cause the thread to pile up and loop. You need to alter the tensions to attain a flat smooth look.
Using Tape for loose ends; Using tape can leave a residue which can cause friction and thread breakage.
